Which Side Of Laminate Goes Against The Wall

The solution is to angle cut the lengths of the first and last courses for your laminate floor layout pattern so the floor is straight even if the walls aren t.

Which side of laminate goes against the wall.

If the wall isn t straight and you start a full course of flooring against it then the whole floor will look crooked. The underlayment has a plastic strip on one end that goes along the wall and up the wall that will be covered by the baseboard and the other end has a strip of adhesive tape. In fact laminate flooring can be installed in almost every room in your home including kitchens since it doesn t have to be glued down and doesn t involve grout or mortar. As you unroll each roll the clear plastic end lies on top of the end with adhesive strip and two white pieces of foam will be butted up against each other.

The underlayment cushions the. The tongue on laminate flooring is the small flat edge on one side of the board this is the top edge that is going to angle and lock into the bottom side of another board. The opposite side the bottom side will contain the groove edge which is a larger wider side that contains a lip to hold the boards together when locked. The first thing that you want to do is lay out your first few rows of laminate flooring from wall to wall.

Which side is the tongue which the groove and which goes first during installation the tongue is the side that you will want to place against the wall as you start your laminate flooring installation. How to properly lay laminate floor underlayment. You want to somewhat have the laminate or vinyl plank close to where it is going to be so you don t cut a plank short or long. Starting in the left corner place 1 4 spacers 2 per plank against the wall for expansion and contraction.

I hope this information shall be of benefit to you and good luck with the project. The underlayment has a plastic strip on one end that goes along the wall and up the wall that will be covered by the baseboard and the other end has a strip of adhesive tape. As you unroll each roll the clear plastic end lies on top of the end with adhesive strip and two white pieces of foam will be butted up against each other. You will have to make a cut or two for your beginning and end piece.

This gap will get covered up by baseboard trim or quarter round molding after the flooring is complete then join the first row together with the tongue side against the wall and slide it against the spacers. If you were installing a hardwood floor you would always place the groove against the wall so the floor nailing gun would be able to fire the nails into the tongue.